A Cr/Sc mirror for the water window
A 400-bilayer chromium/scandium mirror calculated at 3.12 nm, just above the scandium L edge: ideal peak reflectivity, bandwidth and angle dependence.
Why this design
Chromium/scandium mirrors work just above the scandium L absorption edge near 3.11 nm. That sits inside the water window between the carbon and oxygen K edges, where water is comparatively transparent and carbon absorbs.
Design inputs
| Input | Value |
|---|---|
| Bilayers | 400 |
| Period d | 1.5575 nm |
| Absorber fraction Γ | 0.4 |
| Absorber | 0.623 nm Cr, 7.19 g/cm³ |
| Spacer (on top) | 0.934 nm Sc, 2.985 g/cm³ |
| Substrate | Si, 2.33 g/cm³ |
| Wavelength range | 3.09–3.15 nm, 161 points |
| Illumination | Normal incidence, unpolarized |
| Interfaces | Smooth (no roughness) |
Calculated result
| Bilayers | Peak reflectivity (%) | Peak wavelength (nm) | FWHM (nm) | R at 3.12 nm (%) |
|---|---|---|---|---|
| 100 | 35.80 | 3.1180 | 0.0225 | 34.73 |
| 200 | 56.63 | 3.1193 | 0.0162 | 56.43 |
| 400 | 62.28 | 3.1203 | 0.0136 | 62.26 |
Adding bilayers raises the peak and narrows it until absorption in the upper layers stops deeper interfaces from contributing. Past that point, more layers add deposition time and accumulated thickness error without adding reflectance.
| Angle from normal (°) | Peak reflectivity (%) | Peak wavelength (nm) | FWHM (nm) | R at 3.12 nm (%) |
|---|---|---|---|---|
| 0 | 62.28 | 3.1203 | 0.0136 | 62.26 |
| 2.5 | 61.08 | 3.1190 | 0.0134 | 59.55 |
| 5 | 43.80 | 3.1149 | 0.0140 | 14.28 |
| 10 | 12.25 | 3.0740 | 0.0156 | 0.80 |
The peak moves to shorter wavelength as the angle from normal grows, so reflectivity at the fixed design wavelength falls even while the peak itself survives. The angle rows are calculated over a wider wavelength range so the shifted peak stays in view. A mirror used off-normal needs a longer period.
What this model leaves out
With a period near 1.56 nm, each film is only a few atoms thick. Interface roughness of a few tenths of a nanometer reduces the reflectance of fabricated mirrors far below this smooth-interface result. Tabulated optical constants are also least reliable close to an absorption edge.
The calculation uses bundled reference optical constants and a planar stack. It does not establish mechanical strength, thermal behavior, lifetime or fabrication feasibility.
Next steps
- Open the design in the app and confirm the inputs match the table above.
- Add interface roughness or a capping layer and compare against the pinned ideal design.
- Run a wavelength × angle map over your illumination range, then a thickness-tolerance analysis against your reflectivity requirement.
Calculated with the production solver from the bundled optical reference tables, not measured samples. Example-data fingerprint: 1f022e35fcfc99b7. Assumptions and data sources.