A Mo/Si mirror for 13.5 nm

A 40-bilayer molybdenum/silicon mirror calculated at 13.5 nm: peak reflectivity, bandwidth, and how both change with bilayer count and incidence angle.

EUV Insight · Calculated example · Updated
0%12.420%12.940%13.560%14.180%14.6Wavelength (nm)
40 Mo/Si bilayers on silicon: 73.0% peak reflectance at 13.48 nm. Reflectance versus wavelength; the dashed line marks 13.5 nm. Normal incidence, unpolarized, smooth interfaces. Calculated, not measured.
Open this design in the app ProRepeated multilayers require Pro.

Why this design

Molybdenum and silicon are the standard pair for 13.5 nm optics. Silicon absorbs little just above its L absorption edge near 12.4 nm, and molybdenum supplies the refractive-index contrast, so reflections from many interfaces add in phase.

Design inputs

Inputs for the Mo/Si · 13.5 nm example
InputValue
Bilayers40
Period d6.9 nm
Absorber fraction Γ0.4
Absorber2.760 nm Mo, 10.22 g/cm³
Spacer (on top)4.140 nm Si, 2.33 g/cm³
SubstrateSi, 2.33 g/cm³
Wavelength range12.4–14.6 nm, 221 points
IlluminationNormal incidence, unpolarized
InterfacesSmooth (no roughness)

Calculated result

How the peak builds as bilayers are added (normal incidence)
BilayersPeak reflectivity (%)Peak wavelength (nm)FWHM (nm)R at 13.5 nm (%)
1031.3213.451.2531.21
2060.5213.450.8160.09
4073.0113.480.6372.94

Adding bilayers raises the peak and narrows it until absorption in the upper layers stops deeper interfaces from contributing. Past that point, more layers add deposition time and accumulated thickness error without adding reflectance.

The same stack at other incidence angles
Angle from normal (°)Peak reflectivity (%)Peak wavelength (nm)FWHM (nm)R at 13.5 nm (%)
073.0113.480.6372.94
7.572.6513.370.6167.69
1571.3113.030.5712.80
3025.6111.740.500.27

The peak moves to shorter wavelength as the angle from normal grows, so reflectivity at the fixed design wavelength falls even while the peak itself survives. The angle rows are calculated over a wider wavelength range so the shifted peak stays in view. A mirror used off-normal needs a longer period.

What this model leaves out

Deposited Mo/Si mirrors form thin silicide interlayers and carry a capping layer. Neither is in this model, and both lower the peak. Add them as explicit layers, or as interface roughness, before comparing with a measurement.

The calculation uses bundled reference optical constants and a planar stack. It does not establish mechanical strength, thermal behavior, lifetime or fabrication feasibility.

Next steps

  1. Open the design in the app and confirm the inputs match the table above.
  2. Add interface roughness or a capping layer and compare against the pinned ideal design.
  3. Run a wavelength × angle map over your illumination range, then a thickness-tolerance analysis against your reflectivity requirement.

Calculated with the production solver from the bundled optical reference tables, not measured samples. Example-data fingerprint: 1f022e35fcfc99b7. Assumptions and data sources.